1. | Install the front fog bulb. |
2. | Reconnect the lamp connector. |
3. | Install the front bumper. |
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Adjustment
Adjusting method for T/M control cable
1.
Make sure vehicle does not roll
before setting room side shift lever and T/M side manual control lever to
"N" pos ...
Jump starting procedure
1. Make sure the booster battery is 12-
volt and that its negative terminal is
grounded.
2. If the booster battery is in another
vehicle, do not allow the vehicles to
touch.
3. Turn off all ...