Kia Optima: Installation
| • |
In case of the windshield
with reflection layer which reflects the infrared rays in sensing
field, remove the reflection layer from the rain sensor mounting
position prior to installation. |
| • |
Avoid contamination of
the sensor during installation. |
|
| 1. |
Install the rain sensor bracket
to the windshield glass using the tape.
|
It is very important that the coupling pad pushes against the windshield
completely to prevent bubbles from forming at the contact surface. |
|
| 2. |
Connect the rain sensor connector,
and then install the sensor cover. |
The rain sensor may not operate properly if contaminated. Protect the rain
sensor surface by not removing the cover until installatio ...
See also:
Replacement
1.
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Noise and smoke
When the air bags inflate, they make a loud noise and they leave smoke and powder
in the air inside of the vehicle. This is normal and is a result of the ignition
of the air bag inflator. After th ...
Troubleshooting
Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
...
Removal
