Kia Optima: Inspection
| 1. | Check the bushing for wear and deterioration. |
| 2. | Check the front stabilizer bar for deformation. |
| 3. | Check the all bolts and nuts. |
Replacement
1.
Remove the front wheel & tire.
Tightening torque:88.3
~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Release the residual pressure in fuel line (Refer
to “Release Residual Pre ...
Push-Starting
Your manual transaxle-equipped vehicle should not be push-started because it
might damage the emission control system. Vehicles equipped with automatic transaxles
cannot be push-started. Follow th ...
Inspection
1.
Measure terminal-to-terminal
resistance of the blower resistor.
2.
measured resistance is not within
specification, the blower resistor must be replaced. (After re ...
Copyright © www.kiopman.com 2023