Kia Optima: Installation - Trip Switch. Repair procedures - Indicators And Gauges - Body Electrical System - Kia Optima TF 2011-2026 Service ManualKia Optima: Installation

1. Reassemble the steering wheel remote control switch after connecting the connector.
2. Reassemble the steering wheel.
3. Reassemble the driver airbag module.
Make sure the steering remote control switch and the airbag module connectors are plugged in properly.

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group) 3. Remove the steering wheel. (Refe ...

Troubleshooting
Troubleshooting Symptom Possible cause Remedy Tachometer does not operate Cluster fuse (10A) blown Check for short and replac ...

See also:

Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line.The SAS is used to determine turning di ...

RCV Control Solenoid Valve. Specifications
Specification Item Specification Coil Resistance (Ω) 28.3 ~ 31.1 [20°C(68°F)] ...

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with forei ...

Copyright www.kiopman.com 2026