Kia Optima: Installation
Smart Key Unit
| 1. |
Install the smart key unit. |
| 2. |
Install the smart key unit mounting
nuts and bolts and connector. |
| 3. |
Install the glove box housing. |
| 4. |
Install the glove box. |
| 5. |
Install the negative (-) battery
terminal and check the smart key system. |
RF Receiver
| 1. |
Install the RF receiver. |
| 2. |
Install the glove box housing. |
| 3. |
Install the glove box. |
| 4. |
Install the negative (-) battery
terminal and check the smart key system. |
Interior 1 Antenna
| 1. |
Install the interior 1 antenna. |
| 2. |
Install the heater control unit |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
Interior 2 Antenna
| 1. |
Install the interior 2 antenna. |
| 2. |
Install the console rear cover
after connecting the connector. |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
Trunk Antenna
| 1. |
Install the trunk antenna. |
| 2. |
Install the trunk trim. |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
Exterior Bumper Antenna
| 1. |
Install the exterior bumper antenna. |
| 2. |
Install the rear bumper. |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
Buzzer
| 2. |
Install the left side wheel guard. |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
Trunk Lid Open Switch
| 1. |
Install the trunk lid open switch. |
| 2. |
Install the trunk trim. |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
Door Outside Handle
| 1. |
Install the outside handle. |
| 2. |
Install the door trim. |
| 3. |
Install the negative (-) battery
terminal and check the smart key system. |
-
Take care not to scratch
the crash pad and related parts
Smart key unit
1.
Disconnec ...
See also:
Releasing the parking brake
Foot type
To release the parking brake, depress the parking brake pedal a second time while
applying the foot brake. The pedal will automatically extend to the fully released
position.
Hand ...
Component Location Index
Engine Room
1. Receiver Drier
2. Condenser
3. Service Port (High)
4. Service Port (Low)
5. A/C Pressure Transducer
6. Compressor
7. Expansion Val ...
Rail Pressure Sensor (RPS). Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The sensing
element (Semiconductor element) built in ...
Removal
