Kia Optima Manuals

Kia Optima: Installation - Rear Upper Arm. Repair procedures - Rear Suspension System - Suspension System - Kia Optima TF 2011-2026 Service ManualKia Optima: Installation

1. Installation is the reverse of removal.
• If you don't install the jack, the bolt may cut due to the high work load of upper arm mounting bolt.
• Install the component with the specified torques.
• When installing the bolt, install the upper arm in no-load condition by using the transmission jack.
• Install the rear upper arm to the sub frame using a bolt in horizontally aligned condition.
• If tightening the bolt without aligning the bolt holes of rear upper arm and sub frame horizontally, the bolt securing the rear upper arm to the sub frame may come loose and as a result of this, rust and noise may be able to occur later.

Removal
1. Remove the rear wheel & tire. Tightening torque:88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Inspection
1. Check the bushing for wear and deterioration. 2. Check the rear lower arm for deformation. 3. Check the coil spring and spring pad for deterior ...

See also:

Blower Unit. Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad and heater blower unit.(Refer to HA group-heater unit) 3. Re ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A). 3. ...

Installation
1. Reassemble the steering wheel remote control switch after connecting the connector. 2. Reassemble the steering wheel. 3. Reassemble the driver airbag ...

Categories

Kia Optima Manuals

Copyright � www.kiopman.com 2026