Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
| • |
Apply engine oil to the valve O-ring.
|
|
| 1. |
Installation is reverse of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
|
|
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the OTS (A).
3.
Disco ...
Description
Fuel Pressure Regulator Valve is installed on the high pressure
fuel pump and controls fuel flow flowing into the injectors in accordance with
the ECM signal calculated based on var ...
See also:
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch
input (LIN communication) is ON then both wiper low relay and wiper high
relay outputs are controlled by the rain sensor input s ...
Description and Operation
Description
Tread Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire pressure is
below allowed threshold
...
Air Bag Warning
This warning light will
remain on for approximately 6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the light comes on while the vehicle
is ...
Removal
Fuel Pressure Control Valve. Description and Operation