Kia Optima: Removal and Installation
|
1. |
Disconnect the battery negative terminal.
Tightening torque
:4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
|
|
|
2. |
Remove the driver airbag module. (Refer to the RT
group - "Airbag module")
|
|
3. |
Remove the steering wheel. (Refer to the ST group
- "Steering column and shaft") |
|
4. |
Remove the steering wheel cover (A) after loosening
the screws.
|
|
5. |
Disconnect the cruise control switch connector (A)
and then remove the switch.
|
Be careful not to damage the hook when removing
the switch. |
|
|
6. |
Installation is the reverse of removal. |
Measuring Resistance
1.
Disconnect the cruise control switch connector from
the control switch.
2.
Measure resistance between terminals on the con ...
See also:
Winter Driving
We recommend that you carry emergency equipment, including tire chains,
a window scraper, windshield de-icer, a bag of sand or salt, flares, a small
shovel and jumper cables.
Make sure you ...
Changing the Automatic Transaxle Fluid
1. Raise and suitably support the vehicle.
2. Remove the drain plug located at the bottom center front of the transaxle pan.
3. After the oil has drained, completely install a new washer on the plug ...
Installation
1.
Installation is the reverse of
removal.
2.
Use a SST (09581-11000) when
installing the brake caliper assembly.
3.
After installation, bleed ...
Inspection