Kia Optima: Installation
| • |
Install the component with the specified
torques. |
| • |
Note that internal damage may occur when
the component is dropped. If the component has been dropped,
inspect before installing. |
|
| • |
Use care to keep foreign material out of
the valve. |
|
| • |
Install the purge control solenoid valve
after lifting the support pin (A) of the bracket. |
|
| 1. |
Installation is reverse of removal.
Purge control solenoid valve bracket installation
bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,
7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the purge control solenoid valve connector
(A).
3. ...
Description
Continuous Variable Valve Timing (CVVT) system advances or
retards the valve timing of the intake and exhaust valve in accordance with
the ECM control signal which is calculated by ...
See also:
Seatback angle
To recline the seatback:
1. Lean forward slightly and lift up the seatback recline lever. 2. Carefully
lean back on the seat and adjust the seatback of the seat to the position you desire.
3. R ...
Intake Air Temperature Sensor (IATS). Description and Operation
Description
Intake Air Temperature Sensor (IATS) is included inside Manifold
Absolute Pressure Sensor and detects the intake air temperature.To calculate precise air quantity, correction of the ai ...
Installation
•
Do not turn the ignition
switch ON and do not contact the battery cable while replacing the
front impact ...
Removal
CVVT Oil Control Valve (OCV). Description and Operation