1. | Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the MAPS at idle and
IG ON.
|
Keep belts clean and dry
Seat belts should be kept clean and dry. If belts become dirty, they can be cleaned
by using a mild soap solution and warm water. Bleach, dye, strong detergents or
abrasives should not be used bec ...
Replacement
Front brake pads
1.
Loosen the guide rod bolt (B)
and pivot the caliper (A) up out of the way.
Tightening torque:21.6
~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)
...
Installation
1.
Reassemble the steering wheel
remote control switch after connecting the connector.
2.
Reassemble the steering wheel.
3.
Reassemble the driver airbag
...