1. | Measure terminal-to-terminal resistance of the blower resistor. |
2. | measured resistance is not within
specification, the blower resistor must be replaced. (After removing the
resistor)
|
Adjustment
Parking Brake Shoe Clearance Adjustment
1.
Raise the vehicle, and make sure
it is securely supported.
2.
Remove the rear tire and wheel.
3.
Remove the plug ...
Programming
Your vehicles may require the ignition switch to be turned to the "ACC" position
for programming and/or operation of HomeLink. It is also recommended that a new
battery be replaced in th ...
Operating door locks from inside the vehicle
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the button will be visible.
To lock a door, push the door lock button ...