Kia Optima: Inspection
| 1. |
Check that the red light flickers
when the door lock or unlock button is pressed on the transmitter. |
| 2. |
Remove the battery (A) and check
voltage if the red light doesn't flicker.
|
| 3. |
Insert the battery (A) into the
tester (09954-2P100).
|
| 4. |
Push the test button and If "0.00"
is displayed on screen, it means that the battery voltage is 2V or less. |
| 5. |
If "L" is displayed on screen,
it means that the battery is low power and it needs to replace. |
| 6. |
To prevent the discharge of electricity,
turn the tester power off. |
| 7. |
Replace the transmitter battery
with a new one, if voltage is low power then try to lock and unlock the
doors with the transmitter by pressing the lock or unlock button five or
six times. |
| 8. |
If the doors lock and unlock,
the transmitter is O.K, but if the doors don't lock and unlock, register
the transmitter code, then try to lock and unlock the doors. |
| 9. |
If the doors lock and unlock,
the transmitter is O.K, but if the doors don't lock and unlock, replace
the transmitter.
|
An inappropriately disposed battery can be harmful to the environment
and human health. Dispose the battery according to your local
law(s) or regulation.
|
|
1.
Open Door.
2.
Connect POWER (B+) and GND, signal
line of Code Saver.
3.
If connection is normal, signal
line is activated and RED LED turns ON.
...
See also:
Inspection
1.
The windshield deicer switch
inputs can be checked using the GDS.
2.
To check the input value of windshield
deicer switch, select option "Body Control Module& ...
Changing the Manual Transaxle Oil
1. Raise and suitably support the vehicle.
2. Remove the drain plug on the bottom of the transaxle.
3. After the oil has drained completely, install a new washer on the plug, reinstall
the drain p ...
Safety Belt Warning Chime
If the driver's lap/shoulder belt is not fastened when the key is turned ON or
if it is unfastened after the key is turned ON, safety belt warning chime sounds
for approximately 6 seconds. ...
Transmitter Code Registration (Using Code Saver)