Kia Optima: Transmitter Code Registration (Using Code Saver)
| 2. |
Connect POWER (B+) and GND, signal
line of Code Saver. |
| 3. |
If connection is normal, signal
line is activated and RED LED turns ON. |
| 4. |
If switch of Code Saver turns
ON, data via signal line will be transmitted. |
| 5. |
BCM enters into Code Save mode
when it receives data from Code Saver and send Code Save Start signal via
signal line. |
| 6. |
Code Saver turns Green LED ON
when it receives Code Save Start signal. |
| 7. |
When you press Lock or Unlock
button of transmitter, BCM will save Codes. |
| 8. |
If there are 2 transmitters for
Code Saving, register by performing item 7). |
| 9. |
If switch of Code Saver turns
OFF or is disconnected, Code Saving mode will be finished. |
Code saving method
NO
|
Saved code
|
Code to change
|
Changed code
|
1
|
A
|
C
|
C (A is deleted)
|
2
|
A, B, C, D
|
E
|
E (A, B, C, D are deleted)
|
3
|
A, B
|
C, D, E
|
C, D
|
4
|
A, B
|
C, C, D
|
C
|
1.
Check that the red light flickers
when the door lock or unlock button is pressed on the transmitter.
2.
Remove the battery (A) and check
voltage if the red light d ...
1.
Connect the DLC cable of GDS
to the data link connector (16 pins) in driver side crash pad lower panel,
turn the power on GDS.
2.
Select the vehicle model ...
See also:
Erasing Programmed Buttons
To erase the three HomeLink buttons, press and hold the two outside buttons until
the indicator light begins to flash (after 20 seconds). Release both buttons.
Individual buttons cannot be erased ...
Vehicle Break-In Process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1 000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the ...
Inspection
1.
Connect the battery voltage and
check the blower motor rotation.
2.
If the blower motor voltage is
not operated well, substitute with a known-good blower m ...
Inspection
Transmitter Code Registration (Using GDS)