Kia Optima: Inspection
| 1. |
Rack bar
| A. |
Check the rack gear for
damage. |
| B. |
Check the rack bar for
bend and deformation. |
|
| 2. |
Pinion assembly
| A. |
Check the pinion gear
for damage |
| B. |
Check the oil seal for
damage. |
|
| 3. |
Check the inside of rack housing
for damage. |
| 4. |
Check the bellows for being torn. |
1.
Remove the dust packing & cap
(A) from the pinion housing.
2.
Loosen the lock nut and then
remove the tie rod end (B) and lock nut (A) from the tie rod ...
See also:
Measurement Point
Measurements should be taken at the center of the hole.
...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature
sensor connector.
3.
Measure resistance between sensor
signal terminal and sensor g ...
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch
input (LIN communication) is ON then both wiper low relay and wiper high
relay outputs are controlled by the rain sensor input s ...
Disassembly
Restraint