Kia Optima: Inspection
1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable. |
2. |
Disconnect the fuel pressure regulator valve connector. |
3. |
Measure resistance between the fuel pressure regulator
valve terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification”
|
|
Refer to "High Pressure Fuel Pump" in this group.
...
See also:
Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the shift
lever to the P(Park) p ...
Intake Air Temperature Sensor (IATS). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and
4.
...
Receiver-Drier. Repair procedures
Replacement
1.
Remove the condenser, and then
remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :20~25N.m
(2.0~2.5kgf.m, 14.5~18.2lb-ft) ...