Kia Optima: Installation
1. |
Installation is the reverse of
removal. |
• |
When installing, apply
the ATF oil or white vaseline to the O-ring (A) not to be damaged.

|
• |
Continue to apply liquid
gasket at application points at the valve body cover with Ø2.5mm
(0.0984in.) thickness.
Liquid gasket Part
name :
Threebond 1281B or LOCTITE FMD-546
|
|
• |
Adding automatic transaxle
fluid. (Refer to "automatic transaxle system" in this group.) |
|
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional
hydraulic pressure adjustment; however, the hydraulic pre ...
Description
SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve
that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve
body.
...
See also:
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the crankshaft position sensor connector
(A).
...
Additional Programming for Rolling Code Devices
For any rolling-code-equipped device; follow the steps below after completing
the "Programming" section. A second person may make the following steps easier.
1. Locate the "learn&quo ...
Manual transaxle
...