Kia Optima: Inspection
| 1. | Turn the ignition switch OFF. |
| 2. | Disconnect the OCV connector. |
| 3. | Measure resistance between the OCV terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
|
Removal
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the OTS (A).
3.
Disco ...
See also:
Reassembly
1.
Wrap tape around the driveshaft
spline(TJ) to prevent damage to the boots.
2.
Apply grease to the joint boot
on the side of the wheel and install the boot.
...
Front Body A
Hood hinge mounting hole (Ø10)
Fender apron upper inner panel tooling hole (Ø6.6)
Front sus ...
Installation
1.
Reassemble the steering wheel
remote control switch after connecting the connector.
2.
Reassemble the steering wheel.
3.
Reassemble the driver airbag
...
Copyright © www.kiopman.com 2022