Kia Optima: Adjustment
Glass Adjustment
| • |
Check the glass run channel
for damage or deterioration, and replace them if necessary. |
|
| 1. |
Remove the rear door trim. |
| 2. |
Remove the glass mounting hole
plug (B). |
| 3. |
Carefully move the glass (A)
until the glass mounting bolts are visible, then loosen them.
|
| 4. |
Check that the glass moves smoothly. |
Door Position Adjustment
| • |
After installing the
door, check for a flush fit with the adjacent body panels, then
check for equal gaps between the front, rear, and bottom, door edges
and the body. Check that the door and body edges are parallel. Before
adjusting, replace the mounting bolts. |
|
| 1. |
Check that the door and body
edges are parallel.
|
| 2. |
Place the vehicle on a firm,
level surface when adjusting the doors. |
| 3. |
Adjust at the hinges (A):
| A. |
Loosen the door mounting
bolts slightly, and move the door in or out until it aligns flush
with the body. |
| B. |
Loosen the hinge mounting
bolts slightly, and move the door backward or forward, up or down
as necessary to equalize the gaps. |
| C. |
Place a shop towel on
the jack to prevent damage to the door when adjusting the door.
Tightening torque:
(B) : 21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)
(C) : 34.3 ~ 41.2 N.m (3.5 ~ 4.2 kgf.m, 25.3 ~ 30.4 lb-ft)
|
|
|
| 4. |
Grease the pivot portions of
the hinges indicated by the arrows. |
| 5. |
Check for water leaks. |
Door Striker Adjustment
Make sure the door latches securely without slamming it.
If necessary adjust the striker (A): The striker nuts are fixed. The striker can
be fine adjusted up or down, and in or out.
| 1. |
Loosen the screws (B) just enough
for the striker to move.
Tightening torque:(B):
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)
|
|
| 2. |
Tap on the striker with a plastic
hammer to adjust the striker. The striker will not move much, but will give
some adjustment. |
| 3. |
Hold the outer handle out, and
push the door against the body to be sure the striker allows a flush fit.
If the door latches properly, tighten the screws and recheck. |
Door Trim Replacement
•
Be careful not to scratch
the door trim and other parts.
•
...
Replacement
Roof Molding Replacement
•
When prying with a flat-tip
screwdriver, wrap it with protective tape, an ...
See also:
Power Door Mirror Actuator. Repair procedures
Inspection
1.
Remove the front door quadrant
delta cover.(Refer to the BD group - "Front door")
2.
Disconnect the power door mirror
connector from the ...
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Tachometer does not operate
Cluster fuse (10A) blown
Check for short and replac ...
Closing the Hood
Check the area under the hood to make certain all filler caps are in place
and that all loose items have been removed.
Lower the hood then push down to properly lock in place.
Check to make ...
Replacement
Body Side Moldings. Repair procedures