Kia Optima: Inspection
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the OTS connector. |
| 4. |
After immersing the thermistor of the sensor into
engine coolant, measure resistance between the OTS terminals 1 and 2. |
| 5. |
Check that the resistance is within the specification.
Specification:
Refer to “Specification”
|
|
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector (A).
3.
Remove the OTS.
...
See also:
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, push the lever upward and release it with the
lever in the OFF position. The wipers will operate conti ...
Front Body B
Hood hinge mounting hole (Ø10)
Fender apron upper inner panel tooling hole (Ø6.6)
Engine mo ...
Checking the engine oil level
2.4 engine
2.0 engine
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach
normal operating temperature.
3. Turn the engine off and wait for a few
min ...
Removal