Kia Optima: Special Service Tools - General Information - Body (Interior and Exterior) - Kia Optima TF 2011-2021 Service ManualKia Optima: Special Service Tools

Special Service Tools

Tool (Number and name)
Illustration
Use
09861-31100
Sealany cut-out tool

Cutting windshield sealant
(use with 09861-31200)
09861-31200
Sealant cutting blade

Cutting windshield sealant
(use with 09861-31100)
09861-31000
Windshield molding remover

Windshield molding removal
09880-4F000
Hog ring clip installer

Hog ring clip installation
09816-2P100
Power silent cutting tool

Tool box for removing panoramaroof
09816-2P110
Air power tool

Air tool for installing blade
09816-2P121
Cutter-1

Blade for removing the front and side area of panoramaroof (This blade has a inclination to push upward.)
09816-2P122
Cutter-2

Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.)
09816-2P123
Cutter-3

Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.)
09816-2P124
Cutter-4

Blade for removing the front and side area of panoramaroof (This blade has a inclination to push downward.)
09816-2P127
Cutter-5

Blade for removing the rear area of panoramaroof
09816-2P130
Cutter-10

Blade for removing the edge area of panoramaroof


Tightening Torque
Items N.m Kgf.m lb-ft Front and rear doors Door hinge to body 34.3 ~ 41.2 3.5 ~ 4.2 25.3 ~ 30.4 ...

Troubleshooting
Troubleshooting Symptom Suspect Area Remedy (Refer to page) Water leaks from sunroof Deteriorated roof lid weatherstrip Replace ...

See also:

Front Hub / Knuckle Components and Components Location
Components 1. Driveshaft nut2. Brake disc3. Hub4. Wheel bearing5. Snap ring6. Dust cover7. Knuckle8. Driveshaft ...

Disarmed stage
The system will be disarmed when: Transmitter - The door unlock button is pressed. - The engine is started. (within 3 seconds) - The ignition switch is in the УONФ position for 30 seconds or ...

ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle ...

Copyright © www.kiopman.com 2021