Kia Optima: TroubleshootingTroubleshooting
|
Symptom |
Suspect Area |
Remedy (Refer to page) |
|
Water leaks from sunroof |
Deteriorated roof lid weatherstrip |
Replace |
|
Excessive roof lid-to-body clearance and improperly fitted weatherstrip |
Adjust |
|
|
Wind noise around sunroof |
Loose or deformed deflector, gaps in body work |
Re-tighten adjust or replace |
|
Noise heard when opening. closing sunroof |
Foreign particles lodged in guide rail |
Check drive cable and guide rails for foreign particles |
|
Loose guide rails and lid |
Re-tighten |
|
|
Motor runs but sunroof does not move or moves only partially |
Foreign particles lodged in guide rail |
Adjust or replace |
|
Incorrect engagement of motor pinion with drive cable |
||
|
Decrease in motor`s clutch slipping force |
||
|
Increased sunroof sliding resistance or interference of sunroof with drive
cables, weatherstrip, etc. due tomal adjustment of sunroof |
||
|
Noise in motor (clutch slipping noise from motor when sunroof is fully opened
or closed is not an unusual noise |
Incorrect engagement of motor pinion with drive cable |
Check pinion installation and Re-tighten motor |
|
Worn out or damaged motor pinion bearing |
Replace motor assembly |
|
|
Worn out or deformed drive cable |
Replace |
|
|
Door glass fails to operate up and down |
Incorrect window glass installation |
Adjust position |
|
Damaged or faulty regulator arm or regulator |
Correct or replace |
|
|
Door does not open or close completely |
Incorrect door installation |
Adjust position |
|
Defective door check assembly |
Correct or replace |
|
|
Door hinge requires grease |
Apply grease |
|
|
Hood does not open or close completely |
Striker and latch not properly aligned |
Adjust |
|
Incorrectly installed hood |
Adjust |
|
|
Incorrect hood bumper height |
Adjust |
|
|
Water leak through windshield end rear window |
Defective seal |
Fill with sealant |
|
Defective flange |
Correct |
Special Service Tools
Body DimensionsAir Bag Warning
This warning light will
remain on for approximately 6 seconds each time you turn the ignition switch ON.
If the system does not operate as described or if the light comes on while the vehicle
is ...
TPMS Receiver. Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver
as a sole part is shipped in this state. Replacement parts
should therefore arr ...
Inspection
1.
Check-points upon head lamp failure
(HID)
(1)
Check the battery voltage.
(Low beam will be on when the battery voltage above 9V.)
(2)
...