Kia Optima: Removal
| 1. | Remove the mirror wiring cover
(A).
|
| 2. | Disconnect the mirror connector
(B) and remove the mounting screw (A).
|
| 3. | Slide the inside rear view mirror
rearward to remove the inside rear view mirror assembly (A).
|
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the
"ON" position.
2.
Cover the front sensor to stop
...
Installation
1.
Install the mirror assembly.
2.
Install the mirror wiring cover
and connector.
...
See also:
Mode Selection
Controls the direction of air flow through the ventilation system.
The air from outlet port flows at any mode. Close the ventilation outlets using
the knob to block the air flow if you do not wan ...
Output Speed Sensor. Schematic Diagrams
Circuit Diagram
...
Checking Brake/Clutch Fluid Level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN indicators on the side of the reservoir.
Before removing the reservoir cap and adding brake flui ...
Copyright © www.kiopman.com 2024