Kia Optima: Inspection - Repair procedures - Electro chromic Inside Rear View Mirror - Body Electrical System - Kia Optima TF 2011-2019 Service ManualKia Optima: Inspection

Check it by the procedure below to see if the function of the ECM is normal.

1. Turn the ignition key to the "ON" position.
2. Cover the front sensor to stop functioning.
3. Shine a light at the rear sensor.
4. The ECM should be darkened as soon as the rear sensor detects the light.
If this test is performed in daytime, the ECM may be darkened as soon as the front sensor is covered.
5. When the reverse gear is engaged, the ECM should not be darkened.
6. When heading lights to both the front and rear sensors, the ECM should not be darkened.

Repair procedures
...

Removal
1. Remove the mirror wiring cover (A). 2. Disconnect the mirror connector (B) and remove the mounting screw (A). 3. Slide the ...

See also:

Changing the Manual Transaxle Oil
1. Raise and suitably support the vehicle. 2. Remove the drain plug on the bottom of the transaxle. 3. After the oil has drained completely, install a new washer on the plug, reinstall the drain p ...

Welcome light (if equipped)
When all the doors (and trunk) are locked and closed, the room lamp will come on for about 15 seconds if any of the below is performed. Without smart key system - When the door unlock butto ...

Canister Close Valve (CCV). Specifications
Specification Item Specification Coil Resistance (Ω) 19.8 ~ 21.8 [20°C(68°F)] ...

Copyright © www.kiopman.com 2019