Removal and Installation
1. | Remove the front muffler (B)
after disconnecting the oxygen sensor connector (A).
|
2. | Remove the catalytic converter
& center muffler assembly (B) after disconnecting the oxygen sensor connector
(A).
|
3. | Remove the main muffler (A).
|
4. | Installation is the reverse order
of removal.
|
Auto Light Switch. Repair procedures
Inspection
Lighting Switch InspectionWith the multi function switch in each position, make
sure that continuity exists between the terminals below. If continuity is not as
specified, replace the ...
Center High-Mounted Stoplight Bulb Replacement
1. Remove the cover and turn the bulb socket counterclockwise and remove it from
the housing.
2. Push the bulb in, then rotate it one- quarter turn counterclockwise and remove
the bulb from the ...
Inspection
1.
Ignition "ON"
2.
Manually operate the control
switch and measure the voltage of blower motor.
3.
Select the control switch to
raise volta ...