Kia Optima: Removal - Anchor Pretensioner (APT). Repair procedures - Seat Belt Pretensioner - Restraint - Kia Optima TF 2011-2019 Service ManualKia Optima: Removal

1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2. To remove the seat belt anchor pretensioner (C), keep on pushing the lock pin (A) as arrow direction. And then remove the seat belt after pushing the lock pin (B).

3. Remove the door scuff trim. (Refer to the Body group- Interior trim)
4. Remove the center pillar trim. (Refer to the Body group- Interior trim)
5. Disconnect the anchor pretensioner connector (C).

6. Loosen the anchor pretensioner mounting bolt and remove the anchor pretensioner.

Anchor Pretensioner (APT). Repair procedures
...

Installation
1. Remove ignition key from the vehicle. 2. Disconnect the negative (-) cable from battery and wait for at least three minutes. 3. Install the ancho ...

See also:

Glass antenna
When the radio power switch is turned on while the ignition key is in either the УONФ or УACCФ position, your car will receive both AM and FM broadcast signals through the antenna in the rear wi ...

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by ...

Removal
1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat assembly.(Refer to the Body gr ...

Copyright © www.kiopman.com 2019