Kia Optima: Removal - Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Kia Optima TF 2011-2018 Service ManualKia Optima: Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve Body" in this group)

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between sensor signal terminal and sensor g ...

26 Brake Control Solenoid Valve(26/B_VFS). Description and Operation
Description 26 brake control solenoid valve(26/B_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26 brake. ...

See also:

Checking Brake/Clutch Fluid Level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN indicators on the side of the reservoir. Before removing the reservoir cap and adding brake flui ...

Driving in the Rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared for the slick pavement. Here are a few things to consider when driving in the rain: A heavy rainfall will make it ...

Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the front knuckle assembly (A) on press. ...

Copyright © www.kiopman.com 2018