1. | Turn ignition switch OFF. |
2. | Disconnect the oil temperature sensor connector. |
3. | Measure resistance between sensor signal terminal and sensor ground terminal. |
4. | Check that the resistance is within the specification. |
Good braking practices
WARNING
Whenever you leave or park your vehicle, always set the parking brake
as far as possible and fully engage the vehicle's transaxle into the P (Park)
position. If the parking brak ...
Heated Oxygen Sensor (HO2S) Schematic Diagrams
Circuit Diagram
...
Purge Control Solenoid Valve (PCSV) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the speci ...