Kia Optima: Installation
Parking Assist Sensor
| 1. |
Connect the connector, and then
install the sensor. |
| 2. |
Install the rear bumper. |
Buzzer
| 2. |
Install the BCM and steering
column assembly. |
| 3. |
Install the crash pad lower panel.
|
RPAS switch
| 1. |
Install the RPAS switch and crash
pad switch assembly. |
| 2. |
Connect the negative (-) battery
terminal. |
Parking Assist Sensor
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the rear bumper.(Refer
to the BD group - "Rear bumper")
3.
...
See also:
Removal
-
Take care not to scratch
the crash pad and related parts
Smart key unit
1.
Disconnec ...
Recommended Shifting
Drive the vehicle in the highest gear that allows the engine to run and accelerate
smoothly without hesitating or stalling. This will give you the most efficient fuel
economy and emission control. ...
Do not lie down
To reduce the chance of injuries in the event of an accident and to achieve maximum
effectiveness of the restraint system, all passengers should be sitting up and the
front seats should be in an u ...
Removal
