Kia Optima: Installation

Removal

1. Disconnect the negative(-) battery terminal. 2. Remove the rear seat.(Refer to the BD group - "Rear seat") 3. Remove the package tray ...

Rear combination lamp. Repair procedures

...

See also:

Installation
1. Install the seat heater switch. 2. Install the power window switch. 3. Install the rear door trim. ...

26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B]▷ Control type : Normal low type Control Pressure kpa(kgf/cm², psi) 9.81~500.14(0.1~5.1, 1.42~72.54) Curren ...

Repair procedures
Inspection Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace t ...