Kia Optima: Removal - High Mounted stop lamp. Repair procedures - Lighting System - Body Electrical System - Kia Optima TF 2011-2019 Service ManualKia Optima: Removal

1. Disconnect the negative(-) battery terminal.
2. Remove the rear seat.

(Refer to the BD group - "Rear seat")

3. Remove the package tray trim (A).

(Refer to the BD group -"Interior trim")

4. Remove the soundproofing felt (A) to remove the wiring.

5. Remove the high mounted stop lamp after removing screws and hook (A) carefully.


High Mounted stop lamp. Repair procedures
...

Installation
1. Install the high mounted stop lamp to the rear package tray. 2. Install the rear package tray trim. 3. Install the rear seat. ...

See also:

Pre-tensioner Seat Belt
Your vehicle is equipped with drivers and front passengers pre-tensioner seat belts. The purpose of the pre-tensioner is to make sure that the seat belts fit tightly against the occupants bod ...

Troubleshooting
Trouble Shooting Ignition System Symptom Suspect area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch ...

Operation of the rear parking assist system
Operating condition This system will activate when backing up with the ignition switch ON. The sensing distance while the rear parking assist system is in operation is approximately 120 cm (4 ...

Copyright www.kiopman.com 2019