Description
1. | The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperatures. |
2. | The sensor output will be used
for discharge temperature control, temperature regulation door control,
blower motor level control, mix mode control and in-car humidity control.
|
Removal
1.
Remove the rear wheel and tire.
Tightening torque:88.3
~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure
as follows. Compare the system condition with normal condition in the table below
and i ...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to
the Diagnostic Trou ...