Kia Optima: Inspection
1. |
Check the brake tubes for cracks,
crimps and corrosion. |
2. |
Check the brake hoses for cracks,
damage and fluid leakage. |
3. |
Check the brake tube flare nuts
for damage and fluid leakage. |
4. |
Check brake hose mounting bracket
for crack or deformation. |
1.
Disconnect the brake fiuid level
switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the
master cylinder reservior with a syringe.
...
1.
Installation is the reverse of
removal.
Use a new washer (A) whenever installing.
...
See also:
Room Lamp Repair procedures
Inspection
Room Lamp
1.
Check that the switch operates properly after disconnecting the room lamp connector (A).
[A type]
[B type]
Removal
Room Lamp
1.
Disconnect the negative(-) battery ...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...