Kia Optima: Removal
| 1. |
Disconnect the brake fiuid level
switch connector, and remove the reservoir cap. |
| 2. |
Remove the brake fluid from the
master cylinder reservior with a syringe.
|
Do not spill brake fluid on the vehicle, it may damage the paint;
if brake fluid does contact the paint, wash it off immediately with
water. |
|
| 3. |
Remove the wheel & tire. |
| 4. |
Remove the brake hose clip (A).
Front
Rear
|
| 5. |
Disconnect the brake tube by
loosening the tube flare nut (B).
Tightening torque:12.7
~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
|
|
| 6. |
Disconnect the brake hose from
the brake caliper by loosening the bolt (C).
Tightening torque:24.5
~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
|
Front
Rear
|
1.
Check the brake tubes for cracks,
crimps and corrosion.
2.
Check the brake hoses for cracks,
damage and fluid leakage.
3.
Check the brake tube flar ...
See also:
Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
3.
Install the crash pad garnish.
...
Reassembly
Thoroughly clean all parts to be assembled.Before installing the parts,
apply fresh engine oil to all sliding and rotating surfaces.
...
Seat belts - Front passenger and rear seat 3-point system with combination locking
retractor
To fasten your seat belt:
Combination retractor type seat belts are installed in the rear seat positions
to help accommodate the installation of child restraint systems. Although a combination
re ...
Inspection