Kia Optima: Inspection - Accelerator Position Sensor (APS). Repair procedures - Engine Control System - Engine Control/Fuel System - Kia Optima TF 2011-2020 Service ManualKia Optima: Inspection

1. Connect the GDS on the Data Link Connector (DLC).
2. Turn the ignition switch ON.
3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to Specification

Accelerator Position Sensor (APS). Repair procedures
...

Removal
Refer to "Accelerator Pedal" in this group. ...

See also:

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to ...

SS-A Solenoid Valve(ON/OFF). Schematic Diagrams
Circuit Diagram ...

Glass antenna
When the radio power switch is turned on while the ignition switch is in either the ON or ACC position, your car will receive both AM and FM broadcast signals through the antenna in the rear ...

Copyright www.kiopman.com 2020