Kia Optima: Accelerator Position Sensor (APS). Repair procedures

Accelerator Position Sensor (APS). Schematic Diagrams

Circuit Diagram ...

Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T ...

See also:

Description
Network ConfigurationThe Network of the SJB(Smart Junction Box) consists of Low speed CAN as shown in the following figure. Termination ResistorThe cluster has CAN termination resistor. It is p ...

Fuel Filter. Repair procedures
Replacement 1. Remove the fuel pump (Refer to “Fuel Pump” in this group). 2. Disconnect the electric pump wiring connector (A) and the fuel sender connecto ...

Starting the engine with an ignition key
1. Make sure the parking brake is applied. 2. Manual Transaxle - Depress the clutch pedal fully and shift the transaxle into Neutral. Keep the clutch pedal and brake pedal depressed while turning t ...