Kia Optima: Components and Components Location

Repair procedures

Refrigerant System Service Basics Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air ...

Component Location Index

Engine Room 1. Receiver Drier 2. Condenser 3. Service Port (High) 4. Service Port (Low) 5. A/C Pressure Transducer 6. Compressor 7. Expansion Val ...

See also:

Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valve opening temperature: 82 ± 1.5°C (17 ...

Inspection
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor's i ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and i ...