Kia Optima: Adjustment - Shift Lever. Repair procedures - 35R Clutch Control Solenoid Valve(35R/C_VFS). Description and Operation - Automatic Transaxle System - Kia Optima TF 2011-2018 Service ManualKia Optima: Adjustment

Adjusting method for T/M control cable
1. Make sure vehicle does not roll before setting room side shift lever and T/M side manual control lever to "N" position.
2. Connect room side shift lever and control cable.
3. Push cable to "F" direction shown to eliminate FREE PLAY.
4. Tighten adjusting nut (A).

Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)


5. After adjusting, check to be sure that this part operates as designed at each range of T/M side corresponding to each position of room lever.
Installation
1. Installation is the reverse of removal. Make sure vehicle does not roll before setting room sid ...

Driveshaft and axle
...

See also:

Reassembly
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel and install the boot. ...

Removal
1. Turn the ignition switch OFF. 2. Remove the air duct (B) and air cleaner assembly (A). 3. Remove the ECM connector (B) and the arrange the ...

Troubleshooting
Trouble Shooting Ignition System Symptom Suspect area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch ...

Copyright © www.kiopman.com 2018