The vehicle will automatically resume the speed set prior to cancellation when you press and release the RES/ACCEL switch, providing the vehicle speed is above 25 mph (40 km/h).
Installation
1.
Remove ignition key from the
vehicle.
2.
Disconnect the negative (-) cable
from battery and wait for at least three minutes.
3.
Install the ancho ...
Inspection
1.
Disconnect the ignition switch
connector (A) and key warning switch connector (B) from the steering column.
2.
Check for continuity between
the ter ...
Inspection
1.
Check signal waveform of Input
& output speed sensor using the GDS.
Specification: Refer to "Signal
Wave Form" section.
...