The tires supplied on your new vehicle are chosen to provide the best performance for normal driving.
The tire label located on the driver's side center pillar gives the tire pressures recommended for your vehicle.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and
5 [B1/S1].
...
Balance Shaft & Oil Pump Repair procedures
Removal
Balance Shaft Module (BSM) Chain System
1.
Remove the timing chain. (Refer to Timing system in this group)
2.
Install a stopper pin (A) after compressing the balance shaft chain tensi ...
Canister Close Valve (CCV) Schematic Diagrams
Circuit Diagram
...