Kia Optima: Inspection

Front Seat Heater Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the floor console upper cover. (Refer to the BD group - "Console")

3.	Remove the seat heater switch connectors from the floor console upper cover (A).

4.	Operate each seat heater switch and check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch [A/T] [M/T]

Rear Seat Heater Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear door trim. (Refer to the BD group - "Rear door")

3.	Remove the power window switch(A).

4.	Turn rear seat heater switch ON and check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch.

Seat Heater Switch. Repair procedures

...

Installation

1. Install the seat heater switch. 2. Install the power window switch. 3. Install the rear door trim. ...

See also:

Balance Shaft & Oil Pump. Repair procedures
...

Battery replacement
When replacement is necessary, use the following procedure. 1. Using a screwdriver, loosen the screw on the backside of the transmitter then use a thin tool to pry open the transmitter. 2. Disas ...

Troubleshooting
Trouble Symptom Charts Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly ...

Categories

Kia Optima Manuals

Copyright © www.kiopman.com 2026