Kia Optima: Securing a child restraint seat with “Tether Anchor” system
Child restraint hook holders are located on the package tray.

1.Route the child restraint seat tether strap over the seatback.
For vehicles with adjustable headrests, route the tether strap under the headrest and between the headrest posts, otherwise route the tether strap over the top of the seatback.
2.Connect the tether strap hook to the appropriate child restraint hook holder and tighten to secure the child restraint seat.
WARNING
When using the vehicle's "Tether Anchor" system to install a child restraint system in the rear seat, all unused vehicle rear seat belt metal latch plates or tabs must be latched securely in their seat belt buckles and the seat belt webbing must be retracted behind the child restraint to prevent the child from reaching and taking hold of unretracted seat belts. Unlatched metal latch plates or tabs may allow the child to reach the unretracted seat belts which may result in strangulation and a serious injury or death to the child in the child restraint.
WARNING - Tether strap
WARNING - Child restraint check
Check that the child restraint system is secure by pushing and pulling it in different directions. Incorrectly fitted child restraints may swing, twist, tip or separate causing death or serious injury.
WARNING
- Child restraint anchorage
Placing a passenger seat belt into the auto lock mode
Securing a child restraint seat with child seat lower anchor systemUsing a child restraint system
Rearward-facing child restraint system
Forward-facing child restraint system
For small children and babies, the use of a child seat or infant seat is required.
This child seat or infant seat s ...
Output Speed Sensor. Description and Operation
Description
The output speed sensor is a vital unit that measures the rate of rotation of the
transaxle's turbine shaft and output shaft, and delivers the readings to the TCM.
The sensor prov ...
Ignition switch position
LOCK
The steering wheel locks to protect against theft. (if equipped) The ignition
key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the k ...