Kia Optima: Rubber Parts And Tubes

Electrical System

1. Be sure to disconnect the battery cable from the negative (-) terminal of the battery. 2. Never pull on the wires when disconnecting connectors. ...

Measuring Body Dimensions

1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twis ...

See also:

Release Residual Pressure in Fuel Line
Whenever the high pressure fuel pump, fuel pipe, delivery pipe, or injector is removed immediately after shutting off the engine, an ...

Installation
1. Install the balance shaft chain. (Refer to Lubrication system in this group) 2. Install the crankshaft chain sprocket (B) and the timing chain oil jet (A). ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition ...