Kia Optima: Replacement
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Using the screwdriver, remove
the side cover (A).
|
| 3. | Loosen the mounting screw and
then remove the crash pad lower cover (A).
|
| 4. | Disconnect the connector (A),
and then remove the crash pad lower cover.
|
| 5. | Using the screwdriver, remove
the center garnish (A).
|
| 6. | Disconnect the connector and
then remove the blower & A/C controller (A).
|
| 7. | Loosen the control panel mounting
screws and then remove the control panel (A).
|
| 8. | Installation is the reverse order of removal. |
Self Diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code
After the display panel flickers three times every 0.5 second, the corresponding
fault code flick ...
See also:
Installation
Side Repeater Lamp
1.
Install the bulb to the side
repeater lamp assembly.
2.
Install the side repeater lamp.
Door Mirror Turn Signal Lamp
1.
Install the do ...
Inspection
[Motor]
1.
Turn ignition switch OFF.
2.
Disconnect the EWGA connector.
3.
Check that the EWGA is stuck by foreign material.
...
Fuel Filter. Repair procedures
Replacement
1.
Remove the fuel pump (Refer to “Fuel Pump” in this
group).
2.
Disconnect the electric pump wiring connector (A)
and the fuel sender conn ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026