Kia Optima Manuals

Kia Optima: Replacement - Mode Control Actuator. Repair procedures - Temperature Control Actuator - Heating,Ventilation, Air Conditioning - Kia Optima TF 2011-2025 Service ManualKia Optima: Replacement

1. Disconnect the negative (-) battery terminal.
2. Using the screwdriver, remove the side cover (A).
3. Loosen the mounting screw and then remove the crash pad lower cover (A).
4. Disconnect the connector (A), and then remove the crash pad lower cover.
5. Remove the shower duct (A).
6. Loosen the mounting bolts and than remove the BCM.

(Refer to BE group - “BCM”)
7. Disconnect the mode control actuator connector (A).
8. Loosen the mounting screw and then remove the mode control actuator (B).
9. Installation is the reverse order of removal.

Inspection
1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode w ...

Blower
...

See also:

Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Component Location Index
Engine Room 1. Receiver Drier 2. Condenser 3. Service Port (High) 4. Service Port (Low) 5. A/C Pressure Transducer 6. Compressor 7. Expansion Val ...

Replacement
Front brake pads 1. Loosen the guide rod bolt (B) and pivot the caliper (A) up out of the way. Tightening torque:21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft) ...

Categories

Kia Optima Manuals

Copyright www.kiopman.com 2025