Kia Optima: Replacement
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Loosen the mounting screw and
then remove the crash pad lower cover (A).
|
| 3. | Remove the evaporator temperature
sensor (A), by pulling it after rotating 90° in a counterclockwise direction.
|
| 4. | Installation is the reverse order of removal. |
Inspection
1.
Ignition "OFF"
2.
Disconnect evaporator temperature
sensor.
3.
Using the multi-tester, Measure
resistance between terminal "1" ...
Photo Sensor. Description and Operation
Description
1.
The photo sensor is located at
the right of defrost nozzle.
2.
The photo sensor contains a photovoltaic
(sensitive to sunlight) diode. The solar radi ...
See also:
Rear wheel alignment
When using a commercially available computerized wheel alignment equipment
to inspect the rear wheel alignment, always position the v ...
Inspection
With the power seat switch in each position, make sure that continuity exists between
the terminals below. If continuity is not as specified, replace the power seat switch.
A : Power seat control s ...
Function
Wiper Control
Washer Control Coupled With Wiper
1.
Under IGN2 = ON, wiper LOW relay
is turned ON after T2 from Washer switch ON if washer switch is ON for T1
and wipe ...
Categories
Kia Optima Manuals
- Kia Optima DL3 2019-2026 Owners Manual
- Kia Optima DL3 2019-2026 Service and Repair Manual
- Kia Optima TF 2011-{2019} Owners Manual
- Kia Optima TF 2011-2026 Service Manual
- Kia Optima MS/Magentis 2000-2005 Owners Manual
Copyright www.kiopman.com 2026