Kia Optima: Replacement
| 1. |
Remove the rear wheel & tire.
Tightening torque:88.3
~ 107.9 N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
|
|
Be careful not to damage the hub bolts when removing the rear wheel
& tire. |
|
| 2. |
Remove the sprit pin and castle
nut and then disconnect the rear assist arm (A) from the rear axle.
Tightening torque:44.1
~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
|
|
| 3. |
Loosen the bolt & nut and then
remove the rear assist arm (A) from the sub frame.
Tightening torque:107.9
~ 117.7N.m(11.0 ~ 12.0kgf.m, 79.6 ~ 86.8lb-ft)
|
|
| 4. |
Installation is the reverse of
removal. |
1.
Check the bushing for wear and
deterioration.
2.
Check for all bolts and nut.
...
See also:
Headlight escort function
The headlights (and/or taillights) will remain on for approximately 20 minutes
after the ignition key is removed or turned to the ACC or LOCK position. However,
if the driver’s door is opened an ...
Wheel replacement
When replacing the metal wheels for
any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
WARNING
A wheel that is not the corr ...
Speed sensing door lock system (if equipped)
All doors will be automatically locked after the vehicle speed exceeds 15 km/h
(9.3 mi/h). And all doors will be automatically unlocked when you turn the engine
off or when you remove the ignition ...
Inspection