Inspection
1. | After disconnecting the vapor hose from the PCV valve, remove the PCV valve. Visually check for a collapsed vapor hose or hose leaks. |
2. | Reconnect the PCV valve to the vapor hose. |
3. |
Run the engine at idle, then put a finger over the
open end of the PCV valve and make sure that intake manifold vacuum
can be felt.
|
4. | If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose. |
Inspection
1.
Check the hands free remote control
switch for resistance between terminals in each switch position.
Switch
Connector
terminal
...
Erasing Programmed Buttons
To erase the three HomeLink buttons, press and hold the two outside buttons until
the indicator light begins to flash (after 20 seconds). Release both buttons.
Individual buttons cannot be erased ...
Description and Operation
Refrigeration Cycle
...