Kia Optima: Repair procedures
Component Replacement After Deployment
|
Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to
the Diagnostic Trouble Code list for repairing of the related DTCs. Check
and repair all DTC's before replacing a faulty or one whose airbag system
has been deployed SRSCM. |
When the front airbag(s) deployed after a collision, replace the following items.
Make sure all DTC's are repaired befor replacing with new SRSCM.
| - |
Seat belt pretensioner(s) |
| - |
Inspect the clock spring for
heat damage. If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the following
items.
| - |
Side impact sensor(s) for the
deployed side(s) |
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
| - |
Turn the ignition switch ON;
the SRS indicator should come on for about six seconds and then go off. |
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM
activates the warning lamp for a ...
See also:
ODS (Occupant Detection System)
Your vehicle is equipped with an ODS in the front passenger's seat.
The ODS is designed to detect the presence of a properly-seated front passenger
and determine if the passenger's front ...
To Reset at a Faster Speed
1. Push the RES/ACCEL switch and hold it.
2. Accelerate to desired speed and release the RES/ACCEL switch. While the switch
is pressed, the vehicle will gradually gain speed. ...
Lubricants
Engine
Joint
Lubricants
Quantity
Gasoline 2.0 T-GDI (AT)
BJ
GRB006
145g±10g
TJ
...
Description and Operation
