Kia Optima: Repair procedures
Adjustment
When shift shock is occurred or parts related with the transaxle are replaced, TCM
learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
| 1. |
TCM learning condition
| A. |
ATF temperature: 40~100°C
(104~212°F) |
|
| 2. |
TCM learning procedure
| A. |
Stop learning Repeat
the below shift pattern four times or more with stepping on the
brake.
|
| 1. |
Drive the vehicle through
all gears at D range. Drive from stop to 1st to 2nd to 3rd to 4th
to 5th to 6th with keeping fixed throttle open. |
| 2. |
Down shift from 6th to
5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st. |
| 3. |
Repeat the above driving
pattern four times or more.
Up-shift throttle open : 15~30%
|
|
Fault DiagnosisFeatures a fail-safe mechanism that prevents dangerous situations
from developing in the event of a transaxle failure. The limp home mode engages
if the transaxle malfunctions. ...
See also:
Panoramaroof Switch. Repair procedures
Inspection
1.
Disconnect the negative (-) battery
terminal.
2.
Remove the overhead console lamp
assembly.(Refer to the BD group - "Roof trim")
...
Seatback angle
To recline the seatback:
1. Lean forward slightly and lift up the seatback recline lever. 2. Carefully
lean back on the seat and adjust the seatback of the seat to the position you desire.
3. R ...
Components
1. Duct Seal
2. Duct Case
3. Inlet Door
4. Intake Actuator
5. Inlet Duct Case (A)
6. Climate Control Air Filter
7. Cluster Ionizer
8. Climate Control Air Fi ...
Control System Composition
Schematic Diagrams