1. | Disconnect the negative(-) battery terminal. |
2. | Remove the crash pad lower panel. (Refer to the BD group - "Crash pad") |
3. | Disconnect the start/stop button
connector (A).
|
4. | Remove the start/stop button
(A) after removing the screws.
|
To increase cruise control set speed
Follow either of these procedures:
Move the lever (1) up (to RES+) and hold it. Your vehicle will accelerate.
Release the lever at the speed you want.
Move the lever (1) up (to RES+) and re ...
Gate Operator Programming & Canadian Programming
During programming, your hand-held transmitter may automatically stop transmitting.
Continue to press and hold the HomeLink button while you press and repress ("cycle")
your handheld tran ...
Operation of the rear parking assist system
Operating condition
This system will activate when backing up with the ignition switch ON.
The sensing distance while the rear parking assist system is in operation
is approximately 120 cm (4 ...